Norm

ASTM D4886 - 18 en

Standard Test Method for Abrasion Resistance of Geotextiles (Sandpaper/Sliding Block Method)

45,11 54,58 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 3
Gepubliceerd op 01-02-2018
Taal Engels

1.1 This test method covers the determination of resistance of geotextiles to abrasion using an abrasion tester. This test method at this point has only been evaluated for geotextiles—not geomembranes, grids, etc. Therefore, the test method is designated for geotextiles, not geosynthetics, as all products may not lend themselves to this test method for abrasion. If later developments indicate a wider scope for this test method, appropriate changes will be made.

1.2 The values stated in SI units are to be regarded as standard. The values given in inch-pound units are provided as information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 59.080.70
Engelse titel Standard Test Method for Abrasion Resistance of Geotextiles (Sandpaper/Sliding Block Method)
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen