Norm

ASTM D4940 - 10 en

Standard Test Method for Conductimetric Analysis of Water Soluble Ionic Contamination of Blasting Abrasives

  • Deze norm is ingetrokken sinds 01-12-2015

45,11 54,58 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 3
Gepubliceerd op 01-06-2010
Taal Engels

1.1 This test method describes a procedure for rapid evaluation of abrasives for the presence of ionic contamination by determining the total concentration of water soluble ionic contaminants by means of a conductivity test.

1.2 This test method does not identify the ionic species present nor provide quantitative results on each species.

1.3 This test method is based on a volume comparison among abrasives of similar sizes. A volume comparison is more closely related to surface area of the abrasives than is a weight comparison.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 25.220.10
Engelse titel Standard Test Method for Conductimetric Analysis of Water Soluble Ionic Contamination of Blasting Abrasives
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen