Norm

ASTM D5013 - 89(2009) en

Standard Practices for Sampling Wastes from Pipes and Other Point Discharges

  • Deze norm is ingetrokken sinds 01-09-2016

45,11 54,58 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 3
Gepubliceerd op 01-02-2009
Taal Engels

1.1 Those practices provide guidance for obtaining samples of waste at discharge points from pipes, sluiceways, conduits, and conveyor belts. The following are included:

Sections
Practice ALiquid or Slurry Discharges
Practice BSolid or Semisolid Discharges
7 through 9
10 through 12

1.2 These practices are intended for situations in which there are no other applicable ASTM sampling methods (see Practices D 140 and D 75) for the specific industry.

1.3 These practices do not address flow and time-proportional samplers and other automatic sampling devices.

1.4 Samples are taken from a flowing waste stream or moving waste mass and, therefore, are descriptive only within a certain period. The length of the period for which a sample is descriptive will depend on the sampling frequency and compositing scheme.

1.5 It is recommended that these practices be used in conjunction with Guide D 4687.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 5 for more information.

Details

Engelse titel Standard Practices for Sampling Wastes from Pipes and Other Point Discharges
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen