Norm

ASTM D5028-17

Standard Test Method for Curing Properties of Pultrusion Resins by Thermal Analysis

44,31

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D20.18
Gepubliceerd op 15-07-2017
Taal Engels

1.1 This test method covers determination of curing parameters of pultrusions resins by differential scanning calorimetry.

1.2 This test method is applicable to pultrusion resin solutions with adequate initiator(s).

1.3 The normal operating temperature range is from 0 to 200°C.

Note 1: Resin systems that do not form an adequate baseline are not covered by this test method.

1.4 Computer or electronic based instruments or data treatment equivalent to this practice are suitable for use.

1.5 The values stated in SI units are to be regarded as standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Note 1.

Note 2: There is no known ISO equivalent to this standard.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 83.080.10
Nederlandse titel Standard Test Method for Curing Properties of Pultrusion Resins by Thermal Analysis
Engelse titel Standard Test Method for Curing Properties of Pultrusion Resins by Thermal Analysis

Winkelwagen

Subtotaal:

Ga naar winkelwagen