Norm

ASTM D5081/D5081M-90(2011)e1

Standard Test Method for Aggregate Layer Hiding Power

48,24

Over deze norm

Status Definitief
Aantal pagina's 2
Commissie D08.03
Gepubliceerd op 01-11-2011
Taal Engels

1.1 This test method measures the quantity of aggregate needed to provide an opaque layer under laboratory conditions. Aggregate size Numbers 1 through 8, as listed in Classification D448, may be tested.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. ^REFERENCE:

ASTM Standards:

C702 Practice for Reducing Samples of Aggregate to Testing Size

D75 Practice for Sampling Aggregates

D448 Classification for Sizes of Aggregate for Road and Bridge Construction

D1079 Terminology Relating to Roofing and Waterproofing

Details

ICS-code 87.060.10
Nederlandse titel Standard Test Method for Aggregate Layer Hiding Power
Engelse titel Standard Test Method for Aggregate Layer Hiding Power

Winkelwagen

Subtotaal:

Ga naar winkelwagen