Norm

ASTM D5109-12

Standard Test Methods for Copper-Clad Thermosetting Laminates for Printed Wiring Boards

54,27

Over deze norm

Status Definitief
Aantal pagina's 9
Commissie D09.07
Gepubliceerd op 01-11-2012
Taal Engels

1.1 These test methods cover the procedures for testing copper-clad laminates produced from fiber-reinforced, thermosetting polymeric materials intended for fabrication of printed wiring boards.

1.2 The procedures appear in the following sections:

Procedure

Section

 Referenced Documents

2

 Conditioning

4

 Dielectric Breakdown Voltage Parallel to Laminations

13

 Dimensional Instability

19

 Dissipation Factor

14

 Flammability Rating Test

16

 Flexural Strength, Flatwise at Elevated Temperature

15

 Flexural Strength, Flatwise at Room Temperature

15

 Oven Blister Test

17

 Peel Strength Test at Elevated Temperature

10

 Peel Strength Test at Room Temperature

9

 Permittivity

14

 Pin Holes in Copper Surface

20

 Purity of Copper

5

 Scratches in Copper Surface

21

 Solder Float Test

8

 Solvent Resistance

7

 Surface Resistivity

11

 Volume Resistivity

11

 Terminology

3

 Thickness & Thickness Variation

18

 Warp or Twist

6

 Water Absorption

12


1.3 Metric units are the preferred units for these test methods. Inch-pound units, where shown, are presented for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see 7.2.1, 8.1, and 11.3.1.

Details

ICS-code 31.180
83.140.20
Nederlandse titel Standard Test Methods for Copper-Clad Thermosetting Laminates for Printed Wiring Boards
Engelse titel Standard Test Methods for Copper-Clad Thermosetting Laminates for Printed Wiring Boards

Winkelwagen

Subtotaal:

Ga naar winkelwagen