Norm

ASTM D5175 - 91(2017)e1 en

Standard Test Method for Organohalide Pesticides and Polychlorinated Biphenyls in Water by Microextraction and Gas Chromatography

57,20 69,21 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 12
Gepubliceerd op 15-12-2017
Taal Engels

1.1 This test method (1-3)2 is applicable to the determination of the following analytes in finished drinking water, drinking water during intermediate stages of treatment, and the raw source water:

 Analyte

Chemical Abstract Service
Registry Number A

Alachlor

5972-60-8

 

Aldrin

309-00-2

 

Chlordane

57-74-9

 

Dieldrin

60-57-1

 

Endrin

72-20-8

 

Heptachlor

76-44-8

 

Heptachlor Epoxide

1024-57-3

 

Hexachlorobenzene

118-74-1

 

Lindane

58-89-9

 

Methoxychlor

72-43-5

 

Toxaphene

8001-35-2

 

Aroclor B 1016

12674-11-2

 

Aroclor B 1221

11104-28-2

 

Aroclor B 1232

11141-16-5

 

Aroclor B 1242

53469-21-9

 

Aroclor B 1248

12672-29-6

 

Aroclor B 1254

11097-69-1

 

Aroclor B 1260

11096-82-5

 

(A) Numbering system of CAS Registry Services, P.O. Box 3343, Columbus, OH 43210-0334.
(B) Aroclor is a registered trademark of Monsanto Co.

1.2 Detection limits for most test method analytes are less than 1 μg/L. Actual detection limits are highly dependent on the characteristics of the sample matrix and the gas chromatography system. Table 1 contains the applicable concentration range for the precision and bias statements. Only Aroclor 1016 and 1254 were included in the interlaboratory test used to derive the precision and bias statements. Data for other PCB products are likely to be similar.

(A) Bias = C − X.
(B) X  = Mean recovery.
(C) C = True concentration value.
(D) St = Overall standard deviation.
(E) So = Single analyst standard deviation.

1.3 Chlordane, toxaphene, and Aroclor products (polychlorinated biphenyls) are multicomponent materials. Precision and bias statements reflect recovery of these materials dosed into water samples. The precision and bias statements may not apply to environmentally altered materials or to samples containing complex mixtures of polychlorinated biphenyls (PCBs) and organochlorine pesticides.

1.4 For compounds other than those listed in 1.1 or for other sample sources, the analyst must demonstrate the applicability of this test method by collecting precision and bias data on spiked samples (groundwater, tap water) (4) and provide qualitative confirmation of results by gas chromatography/mass spectrometry (GC/MS) (5) or by GC analysis using dissimilar columns.

1.5 This test method is restricted to use by or under the supervision of analysts experienced in the use of GC and in the interpretation of gas chromatograms. Each analyst must demonstrate the ability to generate acceptable results using the procedure described in Section 13.

1.6 Analytes that are not separated chromatographically, (analytes that have very similar retention times) cannot be individually identified and measured in the same calibration mixture or water sample unless an alternative technique for identification and quantitation exists (see 13.4).

1.7 When this test method is used to analyze unfamiliar samples for any or all of the analytes listed in 1.1, analyte identifications and concentrations should be confirmed by at least one additional technique.

1.8 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.

1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 9.

1.10 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 13.060.50
Nederlandse titel Standard Test Method for Organohalide Pesticides and Polychlorinated Biphenyls in Water by Microextraction and Gas Chromatography
Engelse titel Standard Test Method for Organohalide Pesticides and Polychlorinated Biphenyls in Water by Microextraction and Gas Chromatography

Winkelwagen

Subtotaal:

Ga naar winkelwagen