Norm

ASTM D5205 - 10 en

Standard Classification System for Polyetherimide (PEI) Materials

  • Deze norm is ingetrokken sinds 01-09-2016

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 7
Gepubliceerd op 01-12-2010
Taal Engels

1.1 This classification system covers unfilled, filled, and reinforced polyetherimide materials suitable for injection molding and extrusion.

1.2 This classification system is not intended for the selection of materials, but only as a means to call out plastic materials to be used for the manufacture of parts. The selection of these materials is to be made by personnel with expertise in the plastics field where the environment, inherent properties of the materials, performance of the parts, part design, manufacturing process, and economics are considered.

1.3 The properties included in this classification system are those required to identify the compositions covered. Other requirements necessary to identify particular characteristics important to specialized applications are to be specified by using the suffixes as given in Section 5.

1.4 The values stated in SI units are to be regarded as standard.

1.5 The following precautionary caveat pertains only to the test methods portion, Section 12, of this classification system: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Note 5.

Note 1—There is no known ISO equivalent to this standard.

Details

ICS-code 83.080.20
Engelse titel Standard Classification System for Polyetherimide (PEI) Materials
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen