Norm

ASTM D5224-12

Standard Practice for Compression Molding Test Specimens of Thermosetting Molding Compounds

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie D20.09
Gepubliceerd op 01-04-2012
Taal Engels

1.1 This practice covers the general principles to be followed when compression molding test specimens of thermosetting molding compounds, such as phenolics, aminoplastics, melamine phenolics, epoxies, and unsaturated polyesters.

1.2 Molding conditions are given for amino, phenolic, and allyl molding compounds. The exact molding conditions will vary from material to material, and, if not incorporated in the material specification, shall be agreed upon between the purchaser and the supplier or determined by previous experience with the particular type of material being used

1.3 The values stated in SI units are to be regarded as standard. The values in parentheses are given for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—This standard and ISO 295 address the same subject matter, but differ in technical content.

Details

ICS-code 77.180
Nederlandse titel Standard Practice for Compression Molding Test Specimens of Thermosetting Molding Compounds
Engelse titel Standard Practice for Compression Molding Test Specimens of Thermosetting Molding Compounds

Winkelwagen

Subtotaal:

Ga naar winkelwagen