Norm

ASTM D5235-14

Standard Test Method for Microscopic Measurement of Dry Film Thickness of Coatings on Wood Products

54,27

Over deze norm

Status Definitief
Aantal pagina's 9
Commissie D01.52
Gepubliceerd op 01-12-2014
Taal Engels

1.1 This test method covers the measurement of dry film thickness of coatings applied to a smooth, textured or curved rigid substrate of wood or a wood-based product

1.2 This test method covers the preparation of wood or wood-based specimens for the purpose of microscopic measurement of dry film thickness.

1.3 This test method suggests an analysis of dry film thickness of coatings on wood or wood-based products using a microscopic measurement.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 17.040.20
79.020
Nederlandse titel Standard Test Method for Microscopic Measurement of Dry Film Thickness of Coatings on Wood Products
Engelse titel Standard Test Method for Microscopic Measurement of Dry Film Thickness of Coatings on Wood Products

Winkelwagen

Subtotaal:

Ga naar winkelwagen