Norm

ASTM D5243-92(2013)

Standard Test Method for Open-Channel Flow Measurement of Water Indirectly at Culverts

86,84

Over deze norm

Status Definitief
Aantal pagina's 42
Commissie D19.07
Gepubliceerd op 01-01-2013
Taal Engels

1.1 This test method covers the computation of discharge (the volume rate of flow) of water in open channels or streams using culverts as metering devices. In general, this test method does not apply to culverts with drop inlets, and applies only to a limited degree to culverts with tapered inlets. Information related to this test method can be found in ISO 748 and ISO 1070.

1.2 This test method produces the discharge for a flood event if high-water marks are used. However, a complete stage-discharge relation may be obtained, either manually or by using a computer program, for a gauge located at the approach section to a culvert.

1.3 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 17.120.20
Nederlandse titel Standard Test Method for Open-Channel Flow Measurement of Water Indirectly at Culverts
Engelse titel Standard Test Method for Open-Channel Flow Measurement of Water Indirectly at Culverts

Winkelwagen

Subtotaal:

Ga naar winkelwagen