Norm

ASTM D5265-09(2016)

Standard Test Method for Bridge Impact Testing

49,88

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie D10.21
Gepubliceerd op 01-06-2016
Taal Engels

1.1 This test method is intended to determine the capability of a long package with a narrow cross-section to resist impact near its center when the package is supported only at its ends. This test method allows the user to select from two test options: Option A employs the use of a free-fall drop tester (see Exhibit B), and Option B employs the use of simulated mechanical impact testing equipment (S.M.I.T.E.; see Exhibit A). The two optional procedures are designed to impart the same amount of kinetic energy at impact; therefore, each procedure yields equal damage-producing potential.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

Nederlandse titel Standard Test Method for Bridge Impact Testing
Engelse titel Standard Test Method for Bridge Impact Testing

Winkelwagen

Subtotaal:

Ga naar winkelwagen