Norm

ASTM D5277 - 92(2008) en

Standard Test Method for Performing Programmed Horizontal Impacts Using an Inclined Impact Tester

  • Deze norm is ingetrokken sinds 01-04-2015

45,11 54,58 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 4
Gepubliceerd op 01-04-2008
Taal Engels

1.1 This test method covers the procedures for reproducing and comparing shock damage, such as that which may result from rail switching or pallet marshalling impacts, using an incline impact tester. It is suitable for simulating the types of shock pulses experienced by lading in rail switching of rail cars with standard draft gear, but not for those with long travel draft gear or cushioned underframes. The test method can also be used for pallet marshalling tests.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard..

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards statements, see Section 6.

Details

ICS-code 19.060
Engelse titel Standard Test Method for Performing Programmed Horizontal Impacts Using an Inclined Impact Tester
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen