Norm

ASTM D5306-92(2013)

Standard Test Method for Linear Flame Propagation Rate of Lubricating Oils and Hydraulic Fluids

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie D02.N0
Gepubliceerd op 01-05-2013
Taal Engels

1.1 This test method covers the determination of the linear flame propagation rates of lubricating oils and hydraulic fluids supported on the surfaces of and impregnated into ceramic fiber media. Data thus generated are to be used for the comparison of relative flammability.

1.2 This test method should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test method may be used as elements of fire risk which takes into account all of the factors that are pertinent to an assessment of the fire hazard of a particular end use.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 75.100
75.120
Nederlandse titel Standard Test Method for Linear Flame Propagation Rate of Lubricating Oils and Hydraulic Fluids
Engelse titel Standard Test Method for Linear Flame Propagation Rate of Lubricating Oils and Hydraulic Fluids

Winkelwagen

Subtotaal:

Ga naar winkelwagen