Norm

ASTM D5375/D5375M-98(2011)

Standard Test Methods for Liner Removal at High Speeds from Pressure-Sensitive Label Stock

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D10.14
Gepubliceerd op 01-04-2011
Taal Engels

1.1 These test methods cover the measurement of the adherence of the release liner to the adhesive of a pressure-sensitive adhesive label.

1.2 These test methods provide means of assessing the uniformity of the adhesion to the liner of a given type of pressure-sensitive label. The assessment may be within a sheet or roll between sheets or rolls or between production lots.

1.3 Variation in the label backing, liner, liner release coating, adhesive, and adhesive coating weight, affect the response. Therefore, these methods cannot be used to pinpoint the specific cause(s) of nonuniformity.

1.4 These test methods may not be appropriate to test labels having either relatively stiff backings or stiff liners, or backings showing high stretch at low forces. These characteristics will result in a high variability of the test response that is not a true indication of the real nature of the adhesive bond.

1.5 The values stated in either SI or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system must be used independently, without combining values in any way.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 37.100.10
83.180
Nederlandse titel Standard Test Methods for Liner Removal at High Speeds from Pressure-Sensitive Label Stock
Engelse titel Standard Test Methods for Liner Removal at High Speeds from Pressure-Sensitive Label Stock

Winkelwagen

Subtotaal:

Ga naar winkelwagen