Norm

ASTM D5404/D5404M-12

Standard Practice for Recovery of Asphalt from Solution Using the Rotary Evaporator

43,42

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie D04.25
Gepubliceerd op 01-06-2012
Taal Engels

1.1 This practice is intended to recover asphalt from a solvent using the rotary evaporator to ensure that changes in the asphalt properties during the recovery process are minimized.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.2.1 Residual pressure measurements are shown in both the SI unit of kPa and the commonly used non-standard equivalent unit of mm of Hg.

1.2.2 Measurements of volume and mass are only given in SI units because they are the only units typically used in practice when performing this standard practice.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 91.100.50
93.080.20
Nederlandse titel Standard Practice for Recovery of Asphalt from Solution Using the Rotary Evaporator
Engelse titel Standard Practice for Recovery of Asphalt from Solution Using the Rotary Evaporator

Winkelwagen

Subtotaal:

Ga naar winkelwagen