Norm

ASTM D5544-16

Standard Test Method for On-Line Measurement of Residue After Evaporation of High-Purity Water

54,27

Over deze norm

Status Definitief
Aantal pagina's 9
Commissie D19.03
Gepubliceerd op 01-06-2016
Taal Engels

1.1 This test method covers the determination of dissolved organic and inorganic matter and colloidal material found in high-purity water used in the semiconductor, and related industries. This material is referred to as residue after evaporation (RAE). The range of the test method is from 0.001 μg/L (ppb) to 60 μg/L (ppb).

1.2 This test method uses a continuous, real time monitoring technique to measure the concentration of RAE. A pressurized sample of high-purity water is supplied to the test method's apparatus continuously through ultra-clean fittings and tubing. Contaminants from the atmosphere are therefore prevented from entering the sample. General information on the test method and a literature review on the continuous measurement of RAE has been published.2

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards statements, see Section 8.

Details

ICS-code 71.040.40
Nederlandse titel Standard Test Method for On-Line Measurement of Residue After Evaporation of High-Purity Water
Engelse titel Standard Test Method for On-Line Measurement of Residue After Evaporation of High-Purity Water

Winkelwagen

Subtotaal:

Ga naar winkelwagen