Norm

ASTM D5703-95(2013)

Standard Practice for Preparatory Surface Cleaning for Clay Brick Masonry

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie D01.47
Gepubliceerd op 01-06-2013
Taal Engels

1.1 This practice covers non-abrasive surface cleaning of clay brick masonry to remove surface contaminants such as dirt, grease, loose material, soot, fly ash, hydrocarbon residues, algae, etc. in preparation for the application of water repellent coatings without damaging or altering the surface appearance of the clay brick masonry.

1.2 Procedures included in this practice are water cleaning, detergent water cleaning, pressurized water cleaning, steam cleaning, and acid cleaning. It is not intended for the cleaning of newly constructed brick masonry. Use of procedures described in this practice may not be appropriate where the surface is of a historical nature.

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard information see Section 5 and Note 2 and Note 3.

Details

ICS-code 25.220.10
Nederlandse titel Standard Practice for Preparatory Surface Cleaning for Clay Brick Masonry
Engelse titel Standard Practice for Preparatory Surface Cleaning for Clay Brick Masonry

Winkelwagen

Subtotaal:

Ga naar winkelwagen