Norm

ASTM D5716 - 95(2006) en

Standard Test Method for Measuring the Rate of Well Discharge by Circular Orifice Weir (Withdrawn 2015)

  • Deze norm is ingetrokken sinds 01-11-2015

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 5
Gepubliceerd op 15-09-2006
Taal Engels

1.1 This test method covers construction and operation of a circular orifice weir for measuring the discharge from a well. This test method is a part of a series of standards prepared on the in situ determination of hydraulic properties of aquifer systems by single- or multiple-well tests. Selection of a well discharge measurement test method is described in Guide D5737.

1.2 This test method is common to a number of aquifer test methods and to evaluation of well and pump performance.

1.3 LimitationsThis test method is limited to the description of a method common to hydraulic engineering for the purpose of groundwater discharge measurement in temporary or test conditions.

1.4 Much of the information presented in this test method is based on work performed by the Civil Engineering Department of Purdue University during the late 1940s. The essentials of that work have been presented in a pamphlet prepared by Layne-Bowler, Inc. and updated by Layne Western Company, Inc.

1.5 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 93.025
Engelse titel Standard Test Method for Measuring the Rate of Well Discharge by Circular Orifice Weir (Withdrawn 2015)
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen