Norm

ASTM D5731-08

Standard Test Method for Determination of the Point Load Strength Index of Rock and Application to Rock Strength Classifications

61,51

Over deze norm

Status Definitief
Aantal pagina's 12
Commissie D18.12
Gepubliceerd op 01-01-2008
Taal Engels

1.1 This test method covers the guidelines, requirements, and procedures for determining the point load strength index of rock. This is an index test and is intended to be used to classify rock strength.

1.2 Specimens in the form of rock cores, blocks, or irregular lumps with a test diameter from 30 to 85 mm can be tested by this test method.

1.3 This test method can be performed in either the field or laboratory. The test is typically used in the field because the testing machine is portable, little or minimal specimen preparation is required, and specimens can be tested within a short time frame of being collected.

1.4 This test method applies to medium strength rock (compressive strength over 15 MPa (2200 psi)).

1.5 This test method does not cover which type of specimen should be tested or whether anisotropic factors should be considered. The specifics of the point load test program need to be developed prior to testing and possibly even before sampling. Such specifics would be dependent on the intended use of the data, as well as possible budgetary constraints and possible other factors, which are outside the scope of this test method.

1.6 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D 6026.

1.7 The method used to specify how data are collected, calculated, or recorded in this standard is not directly related to the accuracy to which the data can be applied in design or other uses, or both. How one applies the results obtained using this standard is beyond its scope.

1.8 The values stated in the SI units are to be regarded as standard.

1.9 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 93.020
Nederlandse titel Standard Test Method for Determination of the Point Load Strength Index of Rock and Application to Rock Strength Classifications
Engelse titel Standard Test Method for Determination of the Point Load Strength Index of Rock and Application to Rock Strength Classifications

Winkelwagen

Subtotaal:

Ga naar winkelwagen