Norm

ASTM D5853-11

Standard Test Method for Pour Point of Crude Oils

54,27

Over deze norm

Status Definitief
Aantal pagina's 8
Commissie D02.07
Gepubliceerd op 01-06-2011
Taal Engels

1.1 This test method covers two procedures for the determination of the pour point temperatures of crude oils down to 36°C. Procedure A provides a measure of the maximum (upper) pour point temperature and is described in 9.1. Procedure B provides a measure of the minimum (lower) pour point temperature and is described in 9.2.

1.2 The use of this test method is limited to use for crude oils. Pour point temperatures of other petroleum products can be determined by Test Method D97.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 WARNING—Mercury has been designated by many regulatory agencies as a hazardous material that can cause central nervous system, kidney and liver damage. Mercury, or its vapor, may be hazardous to health and corrosive to materials. Caution should be taken when handling mercury and mercury containing products. See the applicable product Material Safety Data Sheet (MSDS) for details and EPAs websitehttp://www.epa.gov/mercury/faq.htmfor additional information. Users should be aware that selling mercury and/or mercury containing products into your state or country may be prohibited by law.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 7.

Details

ICS-code 75.040
Nederlandse titel Standard Test Method for Pour Point of Crude Oils
Engelse titel Standard Test Method for Pour Point of Crude Oils

Winkelwagen

Subtotaal:

Ga naar winkelwagen