Norm

ASTM D5948 - 05e1 en

Standard Specification for Molding Compounds, Thermosetting

  • Deze norm is ingetrokken sinds 01-10-2012

57,20 69,21 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 18
Gepubliceerd op 01-03-2005
Taal Engels

1.1 This specification covers the basic properties of thermoset molding compounds and the test methods used to establish the properties.

1.2 ClassificationMolding thermosetting plastic compounds shall be of the following resins and are covered by the individual specification sheets (see 5.1 and Annex A1-Annex A8).

ResinPhenolic, cellulose filledPhenolic, mineral/glass filledMelaminePolyesterDiallyl iso-phthalateDiallyl ortho-phthalateSiliconeEpoxy

Note 1—There is no equivalent ISO standard.

1.3 Order of PrecedenceIn the event of a conflict between the text of this specification and the references cited in Section (except for related specification sheets), the text of this specification takes precedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.

1.4 The values stated in SI units are to be considered standard.

Details

ICS-code 83.040.01
Engelse titel Standard Specification for Molding Compounds, Thermosetting
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen