Norm

ASTM D5948-05(2012)

Standard Specification for Molding Compounds, Thermosetting

61,51

Over deze norm

Status Definitief
Aantal pagina's 20
Commissie D20.16
Gepubliceerd op 01-10-2012
Taal Engels

1.1 This specification covers the basic properties of thermoset molding compounds and the test methods used to establish the properties.

1.2 Classification—Molding thermosetting plastic compounds shall be of the following resins and are covered by the individual specification sheets (see 5.1 and Annex A1-Annex A8).

Resin

Phenolic, cellulose filled

Phenolic, mineral/glass filled

Melamine

Polyester

Diallyl iso-phthalate

Diallyl ortho-phthalate

Silicone

Epoxy


Note 1There is no equivalent ISO standard.

1.3 Order of Precedence—In the event of a conflict between the text of this specification and the references cited in Section 2 (except for related specification sheets), the text of this specification takes precedence. Nothing in this specification, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.

1.4 The values stated in SI units are to be considered standard.

Details

ICS-code 83.040.01
Nederlandse titel Standard Specification for Molding Compounds, Thermosetting
Engelse titel Standard Specification for Molding Compounds, Thermosetting

Winkelwagen

Subtotaal:

Ga naar winkelwagen