Norm

ASTM D5963-04(2015)

Standard Test Method for Rubber Property—Abrasion Resistance (Rotary Drum Abrader)

54,27

Over deze norm

Status Definitief
Aantal pagina's 9
Commissie D11.15
Gepubliceerd op 01-07-2015
Taal Engels

1.1 This test method covers the measurement of abrasion resistance of rubbers (vulcanized thermoset rubbers and thermoplastic elastomers) that are subject to abrasive/frictional wear in actual service. The abrasion resistance is measured by moving a test piece across the surface of an abrasive sheet mounted to a revolving drum, and is expressed as volume loss in cubic millimetres or abrasion resistance index in percent. For volume loss, a smaller number indicates better abrasion resistance, while for the abrasion resistance index, a smaller number denotes poorer abrasion resistance.

1.2 Test results obtained by this test method shall not be assumed to represent the wear behavior of rubber products experienced in actual service.

1.3 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 19.060
83.060
Nederlandse titel Standard Test Method for Rubber Property—Abrasion Resistance (Rotary Drum Abrader)
Engelse titel Standard Test Method for Rubber Property—Abrasion Resistance (Rotary Drum Abrader)

Winkelwagen

Subtotaal:

Ga naar winkelwagen