Norm

ASTM D6037-13e1

Standard Test Methods for Dry Abrasion Mar Resistance of High Gloss Coatings

54,27

Over deze norm

Status Definitief
Aantal pagina's 7
Commissie D01.23
Gepubliceerd op 01-06-2013
Taal Engels

1.1 This test method covers procedures for evaluating the relative mar resistance of high gloss coatings. Two test methods are included. Test Method A uses a device that contains a rotating specimen holder and two abrasive wheels. Test Method B uses a device that contains a reciprocating specimen holder and a single wheel that has been fitted with abrasive paper. Either method can be used to evaluate the dry abrasion mar resistance of coatings applied to planar, rigid surfaces. Each test method provides good discrimination between highly mar resistant coatings.

Note 1The mar resistance values obtained by these test methods have no absolute significance. They should only be used to derive relative performance rankings for test panels that have been prepared from the series of coatings that are currently being evaluated. If mar resistance values are quoted between laboratories, it is essential that a common standard be measured and that the values be compared to that standard. Even then, the values should be used with caution.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 25.220.01
Nederlandse titel Standard Test Methods for Dry Abrasion Mar Resistance of High Gloss Coatings
Engelse titel Standard Test Methods for Dry Abrasion Mar Resistance of High Gloss Coatings

Winkelwagen

Subtotaal:

Ga naar winkelwagen