Norm

ASTM D6073-08a(2013)

Standard Test Method for Relative Setting of Heatset Printing Inks

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie D01.56
Gepubliceerd op 01-06-2013
Taal Engels

1.1 This test method describes the procedure for determining the relative setting speed of heatset inks using a tester consisting of a forced hot air oven and print delivery system.

1.2 This test method is applicable to printing inks intended to be dried by the application of heat and for which a suitable reference standard is available.

1.3 Although heatset inks are normally printed by the offset process, this test method specifies the direct letterpress mode because the higher ink film thicknesses obtained tend to amplify subtle differences in ink setting speed. Prints are prepared by a flatbed printing apparatus using a constant depth printing gage.

1.4 This tester reads temperature and belt speed in nonmetric terms; therefore, instrument settings in this test method are stated first in U.S. Customary Units (inch pound units of measurements). The values given in parentheses are for information only.

1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 87.080
Nederlandse titel Standard Test Method for Relative Setting of Heatset Printing Inks
Engelse titel Standard Test Method for Relative Setting of Heatset Printing Inks

Winkelwagen

Subtotaal:

Ga naar winkelwagen