Norm

ASTM D6111-13a

Standard Test Method for Bulk Density And Specific Gravity of Plastic Lumber and Shapes by Displacement

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie D20.20
Gepubliceerd op 01-09-2013
Taal Engels

1.1 This test method covers the determination of the bulk density and specific gravity of plastic lumber and shapes in their “as manufactured” form. As such, this is a test method for evaluating the properties of plastic lumber or shapes as a product and not a material property test method.

1.2 This test method is suitable for determining the bulk specific gravity or bulk density by immersion of the entire item or a representative cross section in water. This test method involves the weighing of a one piece specimen in water, using a sinker with plastics that are lighter than water. This test method is suitable for products that are wet by, but otherwise not affected by water for the duration of the test.

1.3 Plastic lumber and plastic shapes are currently made predominately from recycled plastics. However, this test method would also be applicable to similar manufactured plastic products made from virgin resins where the product is non-homogeneous in the cross-section.

1.4 The values stated in SI units are to be regarded as standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1There is no known ISO equivalent to this test method.

Details

ICS-code 83.140.01
Nederlandse titel Standard Test Method for Bulk Density And Specific Gravity of Plastic Lumber and Shapes by Displacement
Engelse titel Standard Test Method for Bulk Density And Specific Gravity of Plastic Lumber and Shapes by Displacement

Winkelwagen

Subtotaal:

Ga naar winkelwagen