Norm

ASTM D6117-16

Standard Test Methods for Mechanical Fasteners in Plastic Lumber and Shapes

50,20

Over deze norm

Status Definitief
Aantal pagina's 9
Commissie D20.20
Gepubliceerd op 01-06-2016
Taal Engels

1.1 These test methods cover the evaluation of fastener use with “as manufactured” plastic lumber and shapes through the use of two different testing procedures.

1.2 The test methods appear in the following order:

 

 

Sections

 

Test Method A—Nail, Staple, or Screw Withdrawal Test

4 to 13

 

Test Method B—Lateral Nail, Staple, or Screw Resistance Test

14 to 22

1.3 Plastic lumber and plastic shapes are currently made predominately from recycled plastics. However, these test methods would also be applicable to similar manufactured plastic products made from virgin resins where the product is non-homogeneous in the cross-section.

1.4 The values stated in inch-pound units are to be regarded as standard. The SI units given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1: There is no known ISO equivalent to this standard.

Details

ICS-code 83.140.01
Nederlandse titel Standard Test Methods for Mechanical Fasteners in Plastic Lumber and Shapes
Engelse titel Standard Test Methods for Mechanical Fasteners in Plastic Lumber and Shapes

Winkelwagen

Subtotaal:

Ga naar winkelwagen