Norm

ASTM D6175-03(2013)

Standard Test Method for Radial Crush Strength of Extruded Catalyst and Catalyst Carrier Particles

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie D32.02
Gepubliceerd op 01-03-2013
Taal Engels

1.1 This test method covers and is suitable for determining the resistance of extruded catalysts and catalyst carriers to compressive force from the side.

1.2 This test method was developed using extruded catalyst and catalyst carriers from 1/16 to 1/8 in. in diameter (0.159 to 0.318 cm) and limited to pieces with a length to diameter ratio greater than or equal to 1:1. This test method may be applicable to other diameters.

1.3 This test method is suitable for the determination of mean crush strength per millimetre in the range of 0 to 15 lbf/mm (0 to 65 N/mm).

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations before use.

Details

ICS-code 19.060
Nederlandse titel Standard Test Method for Radial Crush Strength of Extruded Catalyst and Catalyst Carrier Particles
Engelse titel Standard Test Method for Radial Crush Strength of Extruded Catalyst and Catalyst Carrier Particles

Winkelwagen

Subtotaal:

Ga naar winkelwagen