Norm

ASTM D619 - 99(2004) en

Standard Test Methods for Vulcanized Fibre Used for Electrical Insulation (Withdrawn 2013)

  • Deze norm is ingetrokken sinds 01-11-2014

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 7
Gepubliceerd op 10-10-1999
Taal Engels

1.1 These test methods cover the procedures for testing vulcanized fibre sheets, tubes, and rods of such grades as can be used for electrical insulation.

1.2 The procedures appear in the following sections:

ProcedureSectionArc resistanceAshBond strength (ply adhesion)Bursting strengthCompressive strength, , ConditioningDensity, , Dielectric strength, Dimensional measurements, FlammabilityFlexural strength, SilicaTearing strengthTensile strength, , Thickness (sheets)Resistance to impactRockwell hardnessVolatile matterWater absorptionZinc chloride

1.3 The values stated in inch-pound units are to be regarded as the standard. The SI values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in and .

Note 1

The test methods described herein are similar technically to those described in IEC Publication 60667-2. Not all of the tests in this document are included in IEC 60667-2, and the procedures in the two publications are not completely identical; but it is expected that comparable results will be obtained from most of the procedures and comparative tests should be made if necessary before directly comparing results of tests using the different procedures.

Details

ICS-code 29.035.10
Engelse titel Standard Test Methods for Vulcanized Fibre Used for Electrical Insulation (Withdrawn 2013)
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen