Norm

ASTM D6320/D6320M-10(2014)

Standard Test Methods for Single Filament Hose Reinforcing Wire Made from Steel

54,27

Over deze norm

Status Definitief
Aantal pagina's 9
Commissie D13.19
Gepubliceerd op 15-05-2014
Taal Engels

1.1 These test methods cover testing of single filament steel wires that are used to reinforce hose products. By agreement, these test methods may be applied to similar filaments used for reinforcing other rubber products.

1.2 These test methods describe test procedures only and do not establish specifications or tolerances.

1.3 These test methods cover the determinations of the mechanical properties listed below:

 

Property

Section

 

Breaking force (strength)

 7 – 13

 

Yield strength

 7 – 13

 

Elongation

 7 – 13

 

Knot strength

14 – 20

 

Torsion resistance

21 – 27

 

Reverse bend

28 – 34

 

Wrap

35 – 41

 

Diameter

42 – 48


1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.140.65
Nederlandse titel Standard Test Methods for Single Filament Hose Reinforcing Wire Made from Steel
Engelse titel Standard Test Methods for Single Filament Hose Reinforcing Wire Made from Steel

Winkelwagen

Subtotaal:

Ga naar winkelwagen