Norm

ASTM D635-14

Standard Test Method for Rate of Burning and/or Extent and Time of Burning of Plastics in a Horizontal Position

54,27

Over deze norm

Status Definitief
Aantal pagina's 7
Commissie D20.30
Gepubliceerd op 01-12-2014
Taal Engels

1.1 This fire-test-response test method covers a small-scale laboratory screening procedure for comparing the relative linear rate of burning or extent and time of burning, or both, of plastics in the form of bars, molded or cut from sheets, plates, or panels, and tested in the horizontal position.

Note 1: This test method, and test method A of IEC 60695-11-10 are technically equivalent.

Note 2: For additional information on materials which do not burn to the first reference mark by this test, see Test Method D3801.

1.2 This test method was developed for polymeric materials used for parts in devices and appliances. The results are intended to serve as a preliminary indication of their acceptability with respect to flammability for a particular application. The final acceptance of the material is dependent upon its use in complete equipment that conforms with the standard applicable to such equipment.

1.3 The classification system described in Appendix X1 is intended for quality assurance and the preselection of component materials for products.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazards or fire risk assessment of materials, products, or assemblies under actual fire conditions.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazards statements, see 9.2.

Details

ICS-code 13.220.40
83.080.01
Nederlandse titel Standard Test Method for Rate of Burning and/or Extent and Time of Burning of Plastics in a Horizontal Position
Engelse titel Standard Test Method for Rate of Burning and/or Extent and Time of Burning of Plastics in a Horizontal Position

Winkelwagen

Subtotaal:

Ga naar winkelwagen