Norm

ASTM D6442-06(2012)

Standard Test Method for Determination of Copper Release Rate From Antifouling Coatings in Substitute Ocean Water

54,27

Over deze norm

Status Definitief
Aantal pagina's 10
Commissie D01.45
Gepubliceerd op 01-06-2012
Taal Engels

1.1 This test method covers the laboratory determination of the rate at which copper is released from an antifouling (AF) coating in substitute ocean water. The practical limits for quantifying copper release rates by this method are from 1.8 to 500 ??g cm-2d-1. This range may be extended to 0.2 to 500 ??g cm-2d-1 if the analytical procedure described in Appendix X1 is followed.

Note 1???The term ???substitute ocean water??? is used throughout this standard to refer to artificial or synthetic seawater prepared in accordance with Practice D1141.

1.2 The procedure contains the preparation steps for the release rate determination of copper from antifouling paints including apparatus, reagents, holding tank conditions, and sampling point details. Analysis for the concentration of copper in substitute ocean water requires the accurate determination of copper at the low parts ??g L-1 (parts per billion, ppb) level. To detect and correct for reagent impurities, acceptable analytical precision standards are necessary. Therefore, the limit of quantitation (LOQ) for copper in substitute ocean water for the analytical method shall be 10 ??g L-1 (10 ppb) or less. The procedure for determining the LOQ for copper in substitute ocean water for the analytical method is found in Annex A2.

1.3 A suitable method is described in Appendix X1 (graphite furnace atomic absorption spectroscopy, GF-AAS). Other analytical methods may be utilized with relevant procedural changes, as needed, to accommodate selected specific methods. Such methods must meet the limit of quantitation for copper in substitute ocean water of 10 ??g L-1 (10 ppb) or less. See 1.2.

1.4 This results of this test method do not reflect environmental copper release rates for antifouling products, and are not suitable for direct use in the process of generating environmental risk assessments, environmental loading estimates, or for establishing release rate limits for regulatory purposes. See also Section 4 on Significance and Use.

1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety practices and to determine the applicability of regulatory limits prior to use. For specific hazard statements, see Section 7.

Details

ICS-code 87.040
Nederlandse titel Standard Test Method for Determination of Copper Release Rate From Antifouling Coatings in Substitute Ocean Water
Engelse titel Standard Test Method for Determination of Copper Release Rate From Antifouling Coatings in Substitute Ocean Water

Winkelwagen

Subtotaal:

Ga naar winkelwagen