Norm

ASTM D6470-99(2015)

Standard Test Method for Salt in Crude Oils (Potentiometric Method)

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie D02.03
Gepubliceerd op 01-04-2015
Taal Engels

1.1 This test method covers the determination of salt in crude oils. For the purpose of this test method, salt is expressed as % (m/m) NaCl (sodium chloride) and covers the range from 0.0005 % to 0.15 % (m/m).

1.2 The limit of detection is 0.0002 % (m/m) for salt (as NaCl).

1.3 The test method is applicable to nearly all of the heavier petroleum products, such as crude oils, residues, and fuel oils. It may also be applied to used turbine oil and marine diesel fuel to estimate seawater contamination. Water extractable salts, originating from additives present in oils, are codetermined.

1.4 The values stated in SI units are to be regarded as the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 75.180.30
Nederlandse titel Standard Test Method for Salt in Crude Oils (Potentiometric Method)
Engelse titel Standard Test Method for Salt in Crude Oils (Potentiometric Method)

Winkelwagen

Subtotaal:

Ga naar winkelwagen