Norm

ASTM D6511/D6511M-06(2011)e1

Standard Test Methods for Solvent Bearing Bituminous Compounds

54,27

Over deze norm

Status Definitief
Aantal pagina's 9
Commissie D08.05
Gepubliceerd op 01-07-2011
Taal Engels

1.1 These test methods cover procedures for sampling and testing solvent bearing bituminous compounds for use in roofing and waterproofing.

1.2 The test methods appear in the following order:

Section
Sampling4
Uniformity5
Weight per gallon6
Nonvolatile content7
Solubility8
Ash content9
Water content10
Consistency11
Behavior at 60°C [140°F]12
Pliability at 0°C [32°F]13
Aluminum content14
Reflectance of aluminum roof coatings15
Strength of laps of rolled roofing adhered with roof adhesive16
Adhesion to damp, wet, or underwater surfaces17
Mineral stabilizers and bitumen18
Mineral matter19
Volatile organic content20

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 91.100.50
Nederlandse titel Standard Test Methods for Solvent Bearing Bituminous Compounds
Engelse titel Standard Test Methods for Solvent Bearing Bituminous Compounds

Winkelwagen

Subtotaal:

Ga naar winkelwagen