Norm

ASTM D6525/D6525M-16

Standard Test Method for Measuring Nominal Thickness of Rolled Erosion Control Products

44,21

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D35.05
Gepubliceerd op 01-07-2016
Taal Engels

1.1 This test method covers the measurement of the nominal thickness of rolled erosion control products.

1.2 This test method does not provide thickness values for rolled erosion control products under variable compressive stresses. This test method determines nominal thickness, not necessarily minimum thickness.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

Nederlandse titel Standard Test Method for Measuring Nominal Thickness of Rolled Erosion Control Products
Engelse titel Standard Test Method for Measuring Nominal Thickness of Rolled Erosion Control Products

Winkelwagen

Subtotaal:

Ga naar winkelwagen