ASTM D6526 - 10 en

Standard Test Method for Analysis of Toluene by Capillary Column Gas Chromatography

  • Deze norm is ingetrokken sinds 15-03-2012

57,09 62,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 5
Gepubliceerd op 01-06-2010
Taal Engels

1.1 This test method covers the determination of hydrocarbon impurities typically found in, and the purity of, samples containing 98 wt % and greater toluene. This test method is applicable to impurity concentrations in the range of 0.0005 to 1.6 wt %.

1.2 Monocyclic aromatic hydrocarbons containing 6 through 8 carbon atoms, cumene, 1,4dioxane, and nonaromatic aliphatic hydrocarbons containing up to 12 carbon atoms can be detected by this test method. The nonaromatic compounds are determined as a composite.

1.3 The following applies to all specified limits in this test method: for purposes of determining conformance with this test method, an observed value or a calculated value shall be rounded off to the nearest unit in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 9.


ICS-code 71.040.50
Engelse titel Standard Test Method for Analysis of Toluene by Capillary Column Gas Chromatography
Vervangen door



Ga naar winkelwagen