Norm

ASTM D6536/D6536M-00(2010)e1

Standard Test Method for Measuring the Dip Tube Length of a Mechanical Pump Dispenser

48,24

Over deze norm

Status Definitief
Aantal pagina's 2
Commissie F02.30
Gepubliceerd op 01-10-2010
Taal Engels

1.1 This test method covers the measurement technique for a dip tube of a mechanical pump dispenser.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 55.130
Nederlandse titel Standard Test Method for Measuring the Dip Tube Length of a Mechanical Pump Dispenser
Engelse titel Standard Test Method for Measuring the Dip Tube Length of a Mechanical Pump Dispenser

Winkelwagen

Subtotaal:

Ga naar winkelwagen