Norm

ASTM D6749 - 02(2018) en

Standard Test Method for Pour Point of Petroleum Products (Automatic Air Pressure Method)

50,27 60,83 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 5
Gepubliceerd op 01-05-2018
Taal Engels

1.1 This test method covers the determination of pour point of petroleum products by an automatic apparatus that applies a slightly positive air pressure onto the specimen surface while the specimen is being cooled.

1.2 This test method is designed to cover the range of temperatures from −57 °C to +51 °C; however, the range of temperatures included in the (1998) interlaboratory test program only covered the temperature range from −51 °C to −11 °C.

1.3 Test results from this test method can be determined at either 1 °C or 3 °C testing intervals.

1.4 This test method is not intended for use with crude oils.

Note 1: The applicability of this test method on residual fuel samples has not been verified. For further information on the applicability, refer to 13.4.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 75.080
Engelse titel Standard Test Method for Pour Point of Petroleum Products (Automatic Air Pressure Method)
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen