Norm

ASTM D6823-08(2013)

Standard Specification for Commercial Boiler Fuels With Used Lubricating Oils

54,27

Over deze norm

Status Definitief
Aantal pagina's 7
Commissie D02.P0
Gepubliceerd op 01-07-2013
Taal Engels

1.1 This specification covers four grades of fuel oil made of at least 25 % used lubricating oils. The four grades of fuel are intended for use in various types of fuel-oil-burning industrial equipment and commercial boilers under various climatic and operating conditions. These fuels are not intended for use in residential heaters.

1.1.1 Grades RFC4, RFC5L, RFC5H and RFC6 are used lubricating oil blends of increasing viscosity, with or without middle distillate or residual fuel oil, or both, that are intended for use in industrial burners and commercial boilers equipped to handle these types of fuels. This specification is for applications where Specification D6448 would not meet the performance or other requirements of the burner or boiler in question.

Note 1For information on the significance of the terminology and test methods used in this specification, see Appendix X1.

1.2 This specification is for use in contracts for the purchase of fuel oils derived from used lubricating oil and for the guidance of consumers of such fuels. This specification does not address the frequency with which any particular test must be run.

1.3 Nothing in this specification shall preclude observance of national or local regulations which can be more restrictive. In some jurisdictions, used oil is considered a hazardous waste and fuels derived from used oil are required to meet certain criteria before use as a fuel.

Note 2For United States federal requirements imposed on used oil generators, transporters and transfer facilities, reprocessors, marketers, and burners, see 40 CFR Part 279.
Note 3The generation and dissipation of static electricity can create problems in the handling of distillate burner fuel oils. For more information on the subject, see Guide D4865.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4.1 Exception—Table 1 and Table X1.1 include inch-pound values in parentheses for information only.

Details

ICS-code 75.100
Nederlandse titel Standard Specification for Commercial Boiler Fuels With Used Lubricating Oils
Engelse titel Standard Specification for Commercial Boiler Fuels With Used Lubricating Oils

Winkelwagen

Subtotaal:

Ga naar winkelwagen