Norm

ASTM D6862-11(2016)

Standard Test Method for 90 Degree Peel Resistance of Adhesives

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie D14.10
Gepubliceerd op 01-05-2016
Taal Engels

1.1 This test method covers the determination of the resistance-to-peel strength of an adhesive bond between one rigid adherend and one flexible adherend when tested at an angle of approximately 90 degrees under specified conditions of preparation and testing.

1.2 A variation in thickness of the adherends will generally influence test values. For this reason, the thickness of the adherends used to make the test specimens shall be specified in the material specification. When no thickness is specified, the flexible adherend shall be 0.60 mm (0.025 in.) thick and the rigid adherend shall be 1.60 mm (0.060 in.) thick.

Note 1: A heavy fabric, such as canvas, has been used as a flexible adherend.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 83.180
Nederlandse titel Standard Test Method for 90 Degree Peel Resistance of Adhesives
Engelse titel Standard Test Method for 90 Degree Peel Resistance of Adhesives

Winkelwagen

Subtotaal:

Ga naar winkelwagen