Norm

ASTM D689 - 17 en

Standard Test Method for Internal Tearing Resistance of Paper

50,60 61,23 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 6
Gepubliceerd op 01-09-2017
Taal Engels

1.1 This test method measures the force perpendicular to the plane of the paper required to tear multiple sheets of paper through a specified distance after the tear has been started, using an Elmendorf-type tearing tester. The measured results can be used to calculate the approximate tearing resistance of a single sheet. In the case of tearing a single sheet of paper, the tearing resistance is measured directly.

Note 1: Similar procedures for making Elmendorf-type tear measurements are found in ISO 1974 and TAPPI T414.

1.2 This test method is not suitable for determining the cross-directional tearing resistance of highly directional boards and papers.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

Engelse titel Standard Test Method for Internal Tearing Resistance of Paper

Winkelwagen

Subtotaal:

Ga naar winkelwagen