Norm

ASTM D7049 - 17 en

Standard Test Method for Metalworking Fluid Aerosol in Workplace Atmospheres

50,60 61,23 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 6
Gepubliceerd op 01-10-2017
Taal Engels

1.1 This test method covers a procedure for the determination of both total collected particulate matter and extractable mass metalworking fluid aerosol concentrations in the range of 0.07 to 5 mg/m3 in workplace atmospheres.

1.2 This test method describes a standardized means of collecting worker exposure information that can be compared to existing exposure databases, using a test method that is also more specific to metal removal fluids.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 13.040.20
Engelse titel Standard Test Method for Metalworking Fluid Aerosol in Workplace Atmospheres
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen