ASTM D705 - 99(2004) en

Standard Specification for Urea-Formaldehyde Molding Compounds

  • Deze norm is ingetrokken sinds 01-12-2012

44,68 54,06 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 2
Gepubliceerd op 01-10-2004
Taal Engels

1.1 This specification covers compression molding thermosetting, urea-formaldehyde molding compounds as further defined in .

1.2 The values stated in SI units are to be regarded as the standard.

Note 1

The properties included in this specification are those required to identify the types of molding compounds covered. There may be other requirements necessary to identify particular characteristics. Transfer or injection molding will usually result in different physical and electrical characteristics than compression molding.

The following safety hazards caveat pertains only to the test method portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 2

ISO 2112-1977(E) is similar but not equivalent to this specification. Product classification and characterization are not the same.


ICS-code 83.140.99
Engelse titel Standard Specification for Urea-Formaldehyde Molding Compounds
Vervangen door



Ga naar winkelwagen