Norm

ASTM D7140/D7140M-13

Standard Test Method to Measure Heat Transfer Through Textile Thermal Barrier Materials

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie D13.52
Gepubliceerd op 15-03-2013
Taal Engels

1.1 This test method covers the evaluation of heat transfer of textile materials which are used as thermal barriers when exposed to a calibrated convective and radiant energy heat source for 60 s.

1.1.1 This standard is used to determine if the heat transfer is sufficient to ignite flammable materials which are contiguous to the textile thermal barriers.

1.2 This standard is used as a means to differentiate textile materials.

1.3 This test method is not intended to measure the insulation properties of materials used in protective clothing.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products or assemblies under actual fire conditions.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 59.080.30
Nederlandse titel Standard Test Method to Measure Heat Transfer Through Textile Thermal Barrier Materials
Engelse titel Standard Test Method to Measure Heat Transfer Through Textile Thermal Barrier Materials

Winkelwagen

Subtotaal:

Ga naar winkelwagen