Norm

ASTM D7193 - 17 en

Standard Specification for Unsintered Pigmented Polytetrafluoroethylene (PTFE) Extruded Film or Tape

45,11 54,58 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 4
Gepubliceerd op 01-09-2017
Taal Engels

1.1 This specification covers unsintered, pigmented, extruded films or tapes manufactured from polytetrafluoroethylene, in nominal thicknesses from 0.025 mm (0.001 in.) to 0.51 mm (0.020 in.), which are 99 % virgin PTFE in composition prior to introducing pigments.

Note 1: For unsintered non-pigmented products refer to Specification D6585.

1.1.1 The use of recycled PTFE for production of unsintered extruded films or tapes has not been identified at this time. When commercial usable processes and materials are available, this specification will be revised to include recycled materials.

1.2 The values stated in SI units are detailed in IEEE/ASTM SI-10 are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 2: Although this specification and ISO 13000-1 (1997) and ISO 13000-2 (1997) differ in approach or detail, data obtained relating to specific properties, using either are technically equivalent.

Note 3: This specification is intended to be a complement to Specification D6585, as the materials covered herein vary significantly enough due to their additives to warrant a stand-alone set of requirements.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 83.140.10
Engelse titel Standard Specification for Unsintered Pigmented Polytetrafluoroethylene (PTFE) Extruded Film or Tape
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen