Norm

ASTM D7249/D7249M-16

Standard Test Method for Facing Properties of Sandwich Constructions by Long Beam Flexure

54,27

Over deze norm

Status Definitief
Aantal pagina's 9
Commissie D30.09
Gepubliceerd op 01-07-2016
Taal Engels

1.1 This test method covers determination of facing properties of flat sandwich constructions subjected to flexure in such a manner that the applied moments produce curvature of the sandwich facing planes and result in compressive and tensile forces in the facings. Permissible core material forms include those with continuous bonding surfaces (such as balsa wood and foams) as well as those with discontinuous bonding surfaces (such as honeycomb).

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.2.1 Within the text, the inch-pound units are shown in brackets.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1: Alternate procedures for determining the compressive strength of unidirectional polymer matrix composites materials in a sandwich beam configuration may be found in Test Method D5467/D5467M.

Details

ICS-code 79.060.01
Nederlandse titel Standard Test Method for Facing Properties of Sandwich Constructions by Long Beam Flexure
Engelse titel Standard Test Method for Facing Properties of Sandwich Constructions by Long Beam Flexure

Winkelwagen

Subtotaal:

Ga naar winkelwagen