ASTM D7254-15

Standard Specification for Polypropylene (PP) Siding


Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D20.24
Gepubliceerd op 01-04-2015
Taal Engels

1.1 This specification establishes requirements and test methods for materials, impact strength, appearance, surface flame spread, and windload resistance of siding products manufactured from polypropylene material. Methods of indicating compliance with this specification are also provided.

1.2 The use of polypropylene recycled plastic in this product shall be in accordance with the requirements in Section 4.

1.3 Siding produced to this specification shall be installed in accordance with manufacturer’s installation instructions for the specific product to be installed.

Note 1: Information with regard to siding maintenance shall be obtained from the manufacturer.

1.4 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information purposes only.

1.5 The following precautionary caveat pertains to the test method portion only, Section 6 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 2: There is no known ISO equivalent to this standard.


ICS-code 91.060.10
Nederlandse titel Standard Specification for Polypropylene (PP) Siding
Engelse titel Standard Specification for Polypropylene (PP) Siding



Ga naar winkelwagen