Norm

ASTM D7305-08a(2013)

Standard Test Method for Reflection Density of Printed Matter

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D01.56
Gepubliceerd op 01-06-2013
Taal Engels

1.1 This test method describes a procedure for measuring reflection density of printed matter using a reflection densitometer or spectrodensitometer.

1.2 This test method is intended primarily for process colors (yellow, magenta and cyan) and black. With appropriate instrumentation, it may also be used for other colors.

1.3 This test method applies to prints made by any printing process on a flat surface, with reflection density values ranging from just above zero, on the unprinted substrate, through to around 2.5 for very dense prints.

1.4 This test method can be used for prints on paper, film or board but not for those on metal or foil. It can be conducted in the pressroom or laboratory.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 37.100.01
Nederlandse titel Standard Test Method for Reflection Density of Printed Matter
Engelse titel Standard Test Method for Reflection Density of Printed Matter

Winkelwagen

Subtotaal:

Ga naar winkelwagen