Norm

ASTM D731-10

Standard Test Method for Molding Index of Thermosetting Molding Powder

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D20.30
Gepubliceerd op 01-05-2010
Taal Engels

1.1 This test method covers the measurement of the molding index (plasticity) of thermosetting plastics ranging in flow from soft to stiff by selection of appropriate molding pressures within the range from 3.7 to 36.5 MPa (530 to 5300 psi).

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—There is no known ISO equivalent to this test method.

Details

ICS-code 83.080.10
Nederlandse titel Standard Test Method for Molding Index of Thermosetting Molding Powder
Engelse titel Standard Test Method for Molding Index of Thermosetting Molding Powder

Winkelwagen

Subtotaal:

Ga naar winkelwagen